- ページ 8

ストリング・マシン Gamma 5003のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gamma 5003 20 ページ。 6 point mounting
Gamma 5003 にも：オーナーズマニュアル (20 ページ), オーナーズマニュアル (19 ページ), オーナーズマニュアル (20 ページ)

ASSEMBLY INSTRUCTIONS

Setting the Gripper Jaw Spacing

The gripper jaws of the tensioner are adjust-

able to accomodate varying string gauges.

If the string slips through the gripper jaws

while pulling tension, rotate the gripper jaw

adjustment screw counter-clockwise.

If the string is damaged while pulling tension,

rotate the gripper jaw adjustment screw

clockwise.

The jaws will be properly adjusted when

there is enough pressure to securely grip the

string without causing damage to the string.

MOUNTING THE FRAME

Adjusting the Frame Support Posts

Loosen the lock bolts of the frame support

posts and space them apart with the frame

support slides separated by the approxi-

mate length of the racquet head. Although it

is not required, it is good practice to center

the support posts on the turntable. Lock one

of the posts in position by tightening the lock

bolt and position the other post until the frame

support slide is positioned near the inside

surface of the racquet frame. Securely

tighten the lock bolt of the second support

post.

Caution: To avoid racquet damage, the

center posts should not contact the racquet

prior to locking down the support posts.

Tightening the Frame Supports

Tighten the Frame Support Slides by turning

the adjustment knob clockwise until snug

against the racquet frame and slight resis-

tance is felt.

Caution: Overtightening the Center Sup-

ports will stretch the head of the racquet and

could cause racquet damage.