Gamma 5003 소유자 매뉴얼 - 페이지 8
{카테고리_이름} Gamma 5003에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma 5003 20 페이지. 6 point mounting
Gamma 5003에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (19 페이지), 소유자 매뉴얼 (20 페이지)
페이지 인쇄
ASSEMBLY INSTRUCTIONS
Setting the Gripper Jaw Spacing
The gripper jaws of the tensioner are adjust-
able to accomodate varying string gauges.
If the string slips through the gripper jaws
while pulling tension, rotate the gripper jaw
adjustment screw counter-clockwise.
If the string is damaged while pulling tension,
rotate the gripper jaw adjustment screw
clockwise.
The jaws will be properly adjusted when
there is enough pressure to securely grip the
string without causing damage to the string.
MOUNTING THE FRAME
Adjusting the Frame Support Posts
Loosen the lock bolts of the frame support
posts and space them apart with the frame
support slides separated by the approxi-
mate length of the racquet head. Although it
is not required, it is good practice to center
the support posts on the turntable. Lock one
of the posts in position by tightening the lock
bolt and position the other post until the frame
support slide is positioned near the inside
surface of the racquet frame. Securely
tighten the lock bolt of the second support
post.
Caution: To avoid racquet damage, the
center posts should not contact the racquet
prior to locking down the support posts.
Tightening the Frame Supports
Tighten the Frame Support Slides by turning
the adjustment knob clockwise until snug
against the racquet frame and slight resis-
tance is felt.
Caution: Overtightening the Center Sup-
ports will stretch the head of the racquet and
could cause racquet damage.
7