- ページ 11

ガレージドアオープナー Centurion SDO-10のPDF インストール手順とユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Centurion SDO-10 19 ページ。 Sectional and tilting door opener

ページを印刷する

11. Disengaging from Garage Door

 Pull down on the Red Coloured Disengage Cord (Fig.9) to disengage the AGDO from the Garage door.

 Important Notes:

a. Never attempt to open/close the Garage door by pulling on the Disengage Cord. Doing so

may result in SERIOUS PERSONAL INJURY, PROPERTY AND/OR AGDO DAMAGE.

b. Always disengage the AGDO with the Garage door in the fully closed position.

c. If attempting to disengage the AGDO from any position other than with the garage door

fully closed ensure that there are no persons and/or property near or directly under the

path of the garage door.

12. Engaging to Garage Door

 Open the garage door by hand so that it is approx 1 meter off the ground.

 Pull down on the Green Coloured Engage Cord. (Fig 9)

 Press the Green Coloured "Run" Button located on the Rear Cover of the AGDO. (Fig.11)

 After a short time the AGDO will self-engage into the Carriage.

 Important Note: If the AGDO runs for some time (first cycle) and then stops without engaging into

the Carriage press the Green Coloured "Run" Button again and the AGDO will self-engage on the

second cycle.

13. Travel Adjustment

Close Direction Garage Door Travel Adjustment

 Locate the 2 Door Travel Adjusting Screws (DTAS) found on the underside of the Power Head. (Fig 10)

 Increase Travel - turn the DTAS marked with the Red arrow clockwise towards "MORE".

 Decrease Travel-turn the DTAS marked with the Red arrow anti-clockwise towards "LESS".

 Important Notes:

a. The AGDO will switch on automatically and "follow the limits" when they are adjusted in

the direction of increased travel.

b. In the fully closed position the garage door should be sitting lightly on the ground with the

rubber weather seal not fully compressed. (sectional garage doors only)

c. LED Indicator (Fig 11) will glow solid once the AGDO reaches the Close Limit position.

Open Direction Garage Door Travel Adjustment

 Locate the 2 Door Travel Adjusting Screws (DTAS) found on the underside of the Power Head. (Fig 10)

 Increase Travel-turn the DTAS marked with the Green arrow anti-clockwise towards "MORE".

 Decrease Travel - turn the DTAS marked with the Green arrow clockwise towards "LESS".

 Important Notes:

a. The AGDO will switch on automatically and "follow the limits" when they are adjusted in

the direction of increased travel.

b. In the fully open position the garage door should not be sitting against the door track

stoppers.

SETTINGS AND ADJUSTMENTS

LESS

Fig 10

WALL

UP FORCE

MIN

MAX

OPEN

LESS

BEAM

PHOTO

SWITCH

- 11 -

SDOPD