- ページ 17
ガレージドアオープナー Centurion SDO-10のPDF インストール手順とユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Centurion SDO-10 19 ページ。 Sectional and tilting door opener
ページを印刷する
24. Thermal Overload
In order to prevent overheating damage the AGDO is equipped with a internal thermal overload switch. In
the event of continuous usage the AGDO may overheat and shut down. After a shut down the thermal
overload switch will automatically reset after a 20 ~ 30 minute cooling period.
25. Wall Switch – Hard Wired
A permanently wired Wall Switch may be connected to the AGDO in a convenient location such as
adjacent to a side entry door into the garage.
Use a normally open momentary contact type switch. (similar to spring loaded door bell type switch)
Connect the Wall Switch to the Output Terminals depicted in Fig.12C.
Important Note: The Wall Switch must be mounted within sight of the garage door and a
reasonable distance away from moving parts. It should be mounted at least 1500mm above the
ground and the Entrapment Warning Label provided must be attached adjacent to and within
clear sight of it.
26. Wall Switch – Wireless
The wireless wall switch provides ease of installation without the need for running hard wires to the
switch and can be mounted in a convenient location such as adjacent to a side entry door into the garage.
The Wireless Wall Switch may be learned into the AGDO as per the procedure outlined in Sec.15 (Hand
Transmitter Code Learning)
The switch can be permanently screwed to the wall through the mounting holes provided or alternatively
"hooked" on the wall providing the convenience of easy demount ability.
Use the mounting template and mounting instructions provided with the switch.
Important Note: The wireless Wall Switch must be mounted within sight of the garage door and a
reasonable distance away from moving parts. It should be mounted at least 1500mm above the
ground and the Entrapment Warning Label provided must be attached adjacent to and within
clear sight of it.
INPUT VOLTAGE:
MAX DOOR HEIGHT:
MAX DOOR WIDTH:
MAX DOOR AREA:
MAX LIFTING CAPACITY:
MAX No. OF CYCLES TO THERMAL CUT OUT:
MOTOR TYPE:
SAFETY OBSTRUCTION FORCE SYSTEM:
DOOR TRAVEL ADJUSTMENT:
RECEIVER CODE STORAGE CAPACITY:
TRANSMITTER FREQUENCY:
LIGHT GLOBE:
DOOR TRAVEL SPEED:
AUTO CLOSE:
PHOTO BEAMS:
OPTIONS AND FEATURES
TECHNICAL SPECIFICATIONS
Specifications are subject to change without prior notice.
230 ~ 240VAC 50Hz
3600mm using 4200mm rail
6500mm
15 Square Meters
Electronically Limited to 400N
Approx 10
½ HP AC 4 Pole Induction
Manually Adjustable Trim Pot
Manually Adjustable Micro Switch
13 Individual Transmitters
433.92 MHz Hopping Code
60Watt Edison screw rough construction
125mm/second
Dip Switch Selectable
Optional
- 17 -
SDOPD