- ページ 5

農機具 CenturionPro XL MEGABUCKERのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。CenturionPro XL MEGABUCKER 12 ページ。

ページを印刷する

GENERAL OPERATIONS

OPERATION OVERVIEW

• Before operating the machine, a section of level ground, clear of debris, hazards and

obstructions should be selected. The machine should be disconnected from the towing vehicle

and leveled using the three leveling jack-screws provided with the machine. Failure to properly

level or support the machine can result in unsafe working conditions and should be avoided.

• Cut plants into single stems or shoots with 4-5 inches (10-12cm) of stem exposed at base of

branch or shoot.

• Ensure all guards are installed and safety precautions are met before powering on machine.

• Turn on power switch and variable speed controls to the desired speeds. Faster speeds work

best for wet material and slower speeds work best for dry material. The roller speed control

knob will "click" with each incremental increase in speed, allowing for precise replication of

roller speed whenever desired (3 clicks, 4 clicks, etc.).

CLEANING & GENERAL MAINTENANCE

• Lock out power and unplug machine before removing any covers, guards or chutes. Close

and secure the covers of the operator control boxes at each end of the machine before

attempting to clean the machine.

• The machine should be cleaned regularly and especially after every day of use or before

a prolonged time of storage, to keep all aspects of the machine functioning properly and

like new.

• It is best to remove any guards, chutes and safety panels for ease of access to the machine

internal areas and for the cleaning of the guards and safety panels, separate of the machine.

• If pressure washing equipment is used, extreme caution must be observed to direct blast

and spray away from electrical components, bearings, chains, etc. Water accumulation

in or around these parts may cause increased wear and damage to the machine, as well

as severe injury or death to anyone operating or nearby the machine when power is

returned to the unit (especially by electrical shock). All pressure washing of the machine

should be kept to a minimum, directed only to specific areas, or avoided completely due

to the potential hazards involved.

For more information or to watch our DIY video tutorials visit cprosolutions.com

• For best results, insert base of stem or shoot into smallest sized nozzle on faceplate that it will fit

without jamming. Once stem or shoot engages rollers, let go and allow machine to draw stem

or shoot through face plate nozzle, removing all flowers in the process.

• If a jam occurs, stop the machine with the emergency stop button, then reset the emergency stop

button by turning it to unlock. Restart the machine in the reverse direction to extract the jammed

stem or shoot. Once the jam is cleared, the speed control knob can be returned to the forward

direction for continued use. It is recommended that all jammed stems or shoots be cleared

immediately to keep from wearing rollers (which are not warranty covered against wear).

• If desired, bare metal parts removed from the machine may be cleaned with denatured,

or isopropyl alcohol. The use of proper safety equipment such as gloves and a face shield

is recommended.

• Rubber rollers are best cleaned by hand scrubbing with mild soap and water for longest

life. The use of solvents or other oil based products may severely damage rollers. Never

use harsh solvents, mineral spirits, or caustic cleaning materials to clean the rollers.

Rollers do wear out over time and are not covered under warranty.

• Use a light spray of drive chain oil on drive chains weekly.

• Grease "Zerk" fittings on bearing blocks annually and after every 40 hours of use to ensure

proper grease supply to roller shaft bearings.

FOR OPTIMAL PERFORMANCE AND LIFE, THE XL MEGABUCKER MUST BE CLEANED AFTER DAILY USE.

OWNERS MANUAL

XL MEGABUCKER