- ページ 16
おもちゃ Century Helicopter Products Predator 70のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Century Helicopter Products Predator 70 20 ページ。
ページを印刷する
End Cap
Only
complete
one end
now!
Insert the M2 threaded rod 10mm into the grey ball link.
Slide the end cap over the carbon tube and make a mark,
remove and sand the carbon up to this mark for better
adhesion. Using JB Weld or Epoxy bond in place. Only
complete one end at this time. Thread the ball link into the
end cap until it stops using threadlock.
#HW6202A Carbon
Support Struts x 2
Insert and mark each end of the carbon struts where the strut
fittings will overlap. Remove and sand down each carbon
end until they slide easily into the fittings. Scratch inside the
fittings also. Using JB Weld or Epoxy, bond the fittings in
place. Make sure each strut has the fittings 90
each other.
#HI6080 Tail
Mount Liner x 2
M2.5x12
Socket
Screw x 2
Wrap the tail mount liners around the tail boom and trim if
necessary. Install the rudder servo mount assembly onto the
tail boom, over the liners and secure using the M2.5 socket
screws. Leave these loose until after the tail pushrod has
been attached. Attach the rudder servo horn, positioning the
16
steel ball at 12-14mm from the servo center.
#HW6065 Tail
Insert 10mm into
grey ball link.
SE & Max 90 only.
0
degrees to
M2.5x12 Socket
Screw x 2
79
#HW6202
Tail Support
Strut Set -
Aluminum
Pushrod Set
The Aluminum support struts are ready for installation.
81
#HI6080 Tail
Servo Mount
Set
M2.5x12 Self
Tapping
Screw x 4
Install the rudder servo into the tail rudder servo mounts
using M2.5 self tapping screws inserted through the top of
the servo grommets into the vertical mounts.
83
#HI6067 Tail Fin Set -
Horizontal & Vertical
Install the decals for the fins at this time.
80
60/70 only.
82
84
60/70 only.