- ページ 18
おもちゃ Century Helicopter Products Predator 70のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Century Helicopter Products Predator 70 20 ページ。
ページを印刷する
#HI6082 Tail
Support Bridge
Assemble the support bridge with M3 hardware. Press each
side onto the support strut and secure with the cable tie
wraps provided.
Cut, sand and bond the
tail pushrod end cap.
Assemble the other pushrod end cap and ball link to mark
and cut the tail pushrod to match the steel ball on the servo.
Bond the end cap in place and fine tune the position by
moving the rudder servo mount and then tighten in place.
#HI6067A Carbon
Vertical Fin
#HI6067 Plastic
Vertical Fin
#HI6068 Front
Gearbox Mount
M3x35 Socket
Screws x 2
Insert the M3 socket screw through the vertical fin and
through the first gearbox mount.
18
91
M3x15 Socket
Screw, M3x8
Flat Washer x 2
& M3 Locknut
Cable Tie x 4
SE & Max 90
only.
Tighten after final
93
positioning.
95
M3x25 Socket
Screws x 2
Tail pushrod
with one end
assembled.
Slide the two tail pushrod clamps over the unfinished end of
the tail pushrod and attach to the tail boom. Press the ball
link onto the steel ball on the tail pitch bellcrank. Position
the one guide infront of the horizontal fin and one half way
between the fin and the mechanics bringing the pushrod to
the right side of the helicopter.
Remove the pushrod from the servo and slide through the
entire range of movement. Continue adjusting the guides
until the pushrod moves very smooth and then secure the tail
guides with the cable ties.
#HI6068 Forward
Gearbox Mount
M3 Locknut x 4
Engage the rear M3 socket screws through the mounts on the
tail gear box and attach the forward gear box mount captur-
ing the tail boom and secure in place with M3 locknuts.
92
#HI6106
Adjustable Tail
Guides
94
96
Carbon or Plastic
Vertical Fin