- ページ 4
防犯カメラ HIKVISION TURBO HD DF7T SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。HIKVISION TURBO HD DF7T Series 11 ページ。
HIKVISION TURBO HD DF7T Series にも： ユーザーマニュアル (10 ページ)
ページを印刷する2 Installation
Before you start:
Please make sure that the device in the package is in
good condition and all the assembly parts are
included.
Make sure that all the related equipment is power-off
during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with
your required output to avoid damage.
Please make sure the wall is strong enough to
withstand three times the weight of the camera and
the mounting.
If the wall is the cement wall, you need to insert
expansion screws before you install the camera. If the
wall is the wooden wall, you can use self-tapping
screw to secure the camera.
If the product does not function properly, please
contact your dealer or the nearest service center. Do
not disassemble the camera for repair or
maintenance by yourself.
2.1 Ceiling Mounting
Steps:
1. Attach the drill template (supplied) to the place
where you want to fix the camera, and then drill the
screw holes and the cable hole in the ceiling
according to the drill template.
Type I Camera：
2. Loosen the three screws on the edge of the bubble
with the supplied screwdriver to remove the bubble.
3. Attach the back box of Type I camera/base plate of
Type II camera to the ceiling and secure them with
supplied self-tapping screws.
Type I Camera：
Figure 2-2 Attach the Back Box/Base Plate
4. Route the cables through the cable hole.
5. Align the cameras with the back box/base plate, and
tighten the set screws to secure the camera with the
back box/base plate.
Figure 2-1 Drill Template
：
T y p e I I C a m e r a
：
T y p e I I C a m e r a