- ページ 7
防犯カメラ HIKVISION TurboHD H0T SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。HIKVISION TurboHD H0T Series 15 ページ。 Turbo hd bullet & dome camera
HIKVISION TurboHD H0T Series にも： ユーザーマニュアル (17 ページ), ユーザーマニュアル (16 ページ), ユーザーマニュアル (17 ページ), ユーザーマニュアル (13 ページ), ユーザーマニュアル (18 ページ), ユーザーマニュアル (15 ページ), ユーザーマニュアル (17 ページ)
ページを印刷する
not, adjust the camera according to the figure
below.
2.2 Ceiling/Wall Mounting of Type II Camera
Before you start:
The ceiling mounting and the wall mounting are similar.
Following takes ceiling mounting as an example.
Steps:
1. Paste the drill template (supplied) to the place
where you want to install the camera.
2. Drill the screw holes according to the drill template,
and the cable hole (optional) on the ceiling.
Note:
Drill the cable hole in the center of the drill template,
when adopting ceiling outlet to route the cable.
3. Route cables through the cable hole or the side
opening.
4. Attach the camera to the ceiling with supplied
screws.
Figure 2-5 Attach the Camera to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
5. Connect the corresponding power cord, and video
cable.
6. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, loosen the trim ring to adjust the angle.
Rotation Position
[0° to 360°]
Figure 2-3 3-Axis Adjustment
Figure 2-4 Drill Template
Figure 2-6 3-Axis Adjustment
Pan Position
[0° to 360°]
Trim Ring
Tilt Position
[0° to 90°]