HIKVISION TurboHD H0T Series Kullanıcı Kılavuzu - Sayfa 7

Güvenlik Kamerası HIKVISION TurboHD H0T Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. HIKVISION TurboHD H0T Series 15 sayfaları. Turbo hd bullet & dome camera
Ayrıca HIKVISION TurboHD H0T Series için: Kullanıcı Kılavuzu (17 sayfalar), Kullanıcı Kılavuzu (16 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kullanıcı Kılavuzu (13 sayfalar), Kullanıcı Kılavuzu (18 sayfalar), Kullanıcı Kılavuzu (15 sayfalar), Kullanıcı Kılavuzu (17 sayfalar)

not, adjust the camera according to the figure

below.

2.2 Ceiling/Wall Mounting of Type II Camera

Before you start:

The ceiling mounting and the wall mounting are similar.

Following takes ceiling mounting as an example.

Steps:

1. Paste the drill template (supplied) to the place

where you want to install the camera.

2. Drill the screw holes according to the drill template,

and the cable hole (optional) on the ceiling.

Note:

Drill the cable hole in the center of the drill template,

when adopting ceiling outlet to route the cable.

3. Route cables through the cable hole or the side

opening.

4. Attach the camera to the ceiling with supplied

screws.

Figure 2-5 Attach the Camera to the Ceiling

Note:

The supplied screw package contains self-tapping



screws, and expansion bolts.

For cement wall/ceiling, expansion bolts are



required to fix the camera. For wooden

wall/ceiling, self-tapping screws are required.

5. Connect the corresponding power cord, and video

cable.

6. Power on the camera to check whether the image

on the monitor is gotten from the optimum angle. If

not, loosen the trim ring to adjust the angle.

Rotation Position

[0° to 360°]

Figure 2-3 3-Axis Adjustment

Figure 2-4 Drill Template

Figure 2-6 3-Axis Adjustment

Pan Position

[0° to 360°]

Trim Ring

Tilt Position

[0° to 90°]