- ページ 5

ラボラトリー機器 CORNING LSE 6705のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。CORNING LSE 6705 8 ページ。 Platform rockers
CORNING LSE 6705 にも：取扱説明書 (12 ページ)

3.3 Adjusting the Angle

Unload the platform. Locate the knob on the right hand side of the rocker. Note the tilt degree

markings on the platform drive rod (front center under platform). Loosen knob on the side by

rotating counterclockwise. Adjust the platform to desired tilt angle. Retighten the knob on

the side by turning clockwise. Test the unit without load to ensure platform is tight.

NOTE: You many need to turn the rocker on and off to change drive rod position before adjusting.

Connect the main power cord to the rocker and then connect the plug end of the cord to a

grounded wall socket. Avoid lines to which powerful electric motors, refrigerators, and similar

devices are connected.

Be careful when you plug the cord to a grounded wall socket. Do not touch plug

with wet hands. Do not pull the plug by the cord.

1. Set the posts (A) through the 4 holes at the corners of the bottom platform.

2. Add a washer (B) and nut (C) to each post.

3. Fit the upper platform (D) on the top of the 4 posts through the corner holes.

4. Screw on the 4 metal knurl nuts (E) to secure the upper platform.

NOTE: Misuse or unauthorized modifications will waive the warranty rights. If the equipment

is used in a manner not specified by the manufacturer, the safety features of the rocker may

be impaired.

Instruction Manual