- ページ 7

船舶用GPSシステム Garmin GPS 17HVS - Receiver ModuleのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Garmin GPS 17HVS - Receiver Module 12 ページ。 Declaration of conformity
Garmin GPS 17HVS - Receiver Module にも：技術仕様 (34 ページ), インストレーション・マニュアル (16 ページ), 技術仕様 (40 ページ), 技術仕様 (37 ページ), 適合宣言 (2 ページ)

ページを印刷する

Garmin GPS 17HVS - Receiver Module 取付説明書

To attach the enclosed pole mount to the GPS 17:

1. Thread the cable though the pole mount.

2. Align the tab on the mount to the notch on the GPS 17.

3. Use the enclosed screws to secure the mount to the base.

Attaching the Pole Mount to the GPS 17

GPSMAP 2006C/2010C & GPS 17

Align notch

To mount the GPS 17 with cable outside mount:

1. Place the cable in the vertical slot along the side of the base of

the unit.

2. Screw the GPS 17 onto the mount. DO NOT overtighten the

head. It is possible to over tighten the unit and cut the cable.

3. With the GPS 17 and mount installed, ﬁll the remaining gap in

the cable exit with a marine sealant.

4. Route the cable away from sources of electronic interference.

To mount the GPS 17 with cable through mount:

1. Position the mount in the desired location and mark the

approximate center of the mount.

2. Drill a hole large enough for the cable to pass through.

3. Slide the cable through the mount and screw the GPS 17 onto

the mount.

4. Fasten the mount to the boat.

5. Route the cable away from sources of electronic interference.

Attaching the GPS 17 to a Pole Mount

Cable run internally

NSTALLATION

NSTRUCTIONS

Cable run externally