Garmin GPS 17HVS - Receiver Module Handleiding voor installatie-instructies - Pagina 7

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Garmin GPS 17HVS - Receiver Module. Garmin GPS 17HVS - Receiver Module 12 pagina's. Declaration of conformity
Ook voor Garmin GPS 17HVS - Receiver Module: Technische specificaties (34 pagina's), Installatiehandleiding (16 pagina's), Technische specificaties (40 pagina's), Technische specificaties (37 pagina's), Conformiteitsverklaring (2 pagina's)

To attach the enclosed pole mount to the GPS 17:

1. Thread the cable though the pole mount.

2. Align the tab on the mount to the notch on the GPS 17.

3. Use the enclosed screws to secure the mount to the base.

Attaching the Pole Mount to the GPS 17

GPSMAP 2006C/2010C & GPS 17

Align notch

To mount the GPS 17 with cable outside mount:

1. Place the cable in the vertical slot along the side of the base of

the unit.

2. Screw the GPS 17 onto the mount. DO NOT overtighten the

head. It is possible to over tighten the unit and cut the cable.

3. With the GPS 17 and mount installed, ﬁll the remaining gap in

the cable exit with a marine sealant.

4. Route the cable away from sources of electronic interference.

To mount the GPS 17 with cable through mount:

1. Position the mount in the desired location and mark the

approximate center of the mount.

2. Drill a hole large enough for the cable to pass through.

3. Slide the cable through the mount and screw the GPS 17 onto

the mount.

4. Fasten the mount to the boat.

5. Route the cable away from sources of electronic interference.

Attaching the GPS 17 to a Pole Mount

Cable run internally

NSTALLATION

NSTRUCTIONS

Cable run externally