Garmin GPS 17HVS - Receiver Module Kurulum Talimatları Kılavuzu - Sayfa 7
Deniz GPS Sistemi Garmin GPS 17HVS - Receiver Module için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Garmin GPS 17HVS - Receiver Module 12 sayfaları. Declaration of conformity
Ayrıca Garmin GPS 17HVS - Receiver Module için: Teknik Özellikler (34 sayfalar), Kurulum Kılavuzu (16 sayfalar), Teknik Özellikler (40 sayfalar), Teknik Özellikler (37 sayfalar), Uygunluk Beyanı (2 sayfalar)
Sayfayı Yazdır
To attach the enclosed pole mount to the GPS 17:
1. Thread the cable though the pole mount.
2. Align the tab on the mount to the notch on the GPS 17.
3. Use the enclosed screws to secure the mount to the base.
Attaching the Pole Mount to the GPS 17
GPSMAP 2006C/2010C & GPS 17
Align notch
To mount the GPS 17 with cable outside mount:
1. Place the cable in the vertical slot along the side of the base of
the unit.
2. Screw the GPS 17 onto the mount. DO NOT overtighten the
head. It is possible to over tighten the unit and cut the cable.
3. With the GPS 17 and mount installed, fill the remaining gap in
the cable exit with a marine sealant.
4. Route the cable away from sources of electronic interference.
To mount the GPS 17 with cable through mount:
1. Position the mount in the desired location and mark the
approximate center of the mount.
2. Drill a hole large enough for the cable to pass through.
3. Slide the cable through the mount and screw the GPS 17 onto
the mount.
4. Fasten the mount to the boat.
5. Route the cable away from sources of electronic interference.
Attaching the GPS 17 to a Pole Mount
Cable run internally
I
I
NSTALLATION
NSTRUCTIONS
Cable run externally
7