- ページ 30

ラベルメーカー Brother Stampcreator PRO SC2000USBのPDF クイック・リファレンスをオンラインで閲覧またはダウンロードできます。Brother Stampcreator PRO SC2000USB 36 ページ。

The draft sheet rollers should be cleaned after 50 draft sheets (1 pack) have been printed.

a Peel off the pre-cut section from the side of the cleaning sheet marked

SIDE A.

☞ Never reuse a cleaning sheet.

Do not use a cleaning sheet that has been folded or damaged or

has had any part of the paper other than the pre-cut section

removed.

b Load the cleaning sheet into the draft tray with side A facing up as

shown in the illustration.

c Insert the draft tray into the draft tray slot.

d Press the Mode button on the SC-2000USB until "CLEAN" appears on

the LCD display.

e Press the Set button to feed in the cleaning sheet, and then eject it from

the exit slot.

☞ Store unused cleaning sheets in their packages and do not expose

them to high temperatures, high humidity or direct sunlight.

The ID label rollers should be cleaned if the ID labels often feed incorrectly.

a Peel off the pre-cut section from the side of the cleaning sheet marked

SIDE A.

☞ Never reuse a cleaning sheet.

Do not use a cleaning sheet that has been folded or damaged or

has had any part of the paper other than the pre-cut section

removed.

b Insert the cleaning sheet into the ID label slot with side A facing toward

the ink ribbon compartment.

c Press the Mode button on the SC-2000USB until "CLEAN" appears on

the LCD display.

d Press the Set button to feed in the cleaning sheet, and then eject it from

the exit slot.

Maintenance

Side A

Draft tray

ID label slot

Side A