- ページ 32

サーバー Fujitsu PRIMERGY TX120 S2のPDF サービス補足マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu PRIMERGY TX120 S2 38 ページ。

Figure 15: Removing the screws

Ê Remove the screws from the system board.

Ê Carefully lift the system board out of the chassis at a slight angle.

Ê Check the settings on the new system board (for a description see the

Technical Manual of the system board).

Ê Insert the system board by holding it at a slight angle.

CAUTION!

Never remove the system board by grabbing the fixed heat sinks!

Be careful not to damage the EMI springs, these are required for the

system to comply with applicable EMC regulations and satisfy cooling

requirements and fire protection measures.

Ê Lower the system board carefully into the chassis.

Ê Adjust the system board. If necessary adjust the position of the system

board with a gentle twisting motion.

Ê Fasten the system board with the screws.

Ê Reconnect the cables to their original connectors (see the cabling plans in

the Options Guide).