Fujitsu PRIMERGY TX120 S2 서비스 보충 설명서 - 페이지 32
{카테고리_이름} Fujitsu PRIMERGY TX120 S2에 대한 서비스 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu PRIMERGY TX120 S2 38 페이지.
페이지 인쇄Figure 15: Removing the screws
Ê Remove the screws from the system board.
Ê Carefully lift the system board out of the chassis at a slight angle.
Ê Check the settings on the new system board (for a description see the
Technical Manual of the system board).
Ê Insert the system board by holding it at a slight angle.
V
CAUTION!
Never remove the system board by grabbing the fixed heat sinks!
Be careful not to damage the EMI springs, these are required for the
system to comply with applicable EMC regulations and satisfy cooling
requirements and fire protection measures.
Ê Lower the system board carefully into the chassis.
Ê Adjust the system board. If necessary adjust the position of the system
board with a gentle twisting motion.
Ê Fasten the system board with the screws.
Ê Reconnect the cables to their original connectors (see the cabling plans in
the Options Guide).