- ページ 22

プリンター Fujitsu ScanPartner 15CのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu ScanPartner 15C 26 ページ。 Image scanner
Fujitsu ScanPartner 15C にも：ユーザーマニュアル (23 ページ), 仕様 (2 ページ), アップグレードマニュアル (6 ページ), 消耗品の交換とクリーニング (7 ページ), インストール手順 (5 ページ)

Question: When I power on the scanner, it makes noises and

stand ready.

Answer: There are two possibilities:

a) You forgot to remove the shipping retainer from the scanner.

Please remove the shipping retainer first.

b) You did not place the scanner on a flat desktop surface. This

may cause the scanner to function improperly.

Question: When I power on the scanner, the lamp does not light.

Answer: The lamp is out of order. In that case, contact your authorized

local dealer to change the lamp. The life time of the lamp is

about 5000 hours.

Question: Getting image from the scanner is not a problem, but when

scanning, the scanner or system will often crash.

Answer: Please check

a) If the cable is firmly seated;

b) Only two SCSI terminators can be connected to your SCSI daisy

chain. One is at the end of the SCSI device, another is already in

your host adapter.

Question: While scanning, the scanner often makes

back and forth.

Answer: Please choose lower speed from the scanner setup for low speed

PC.

Question: The scanned image always comes out to be too dark.

Answer: Adjust scanner settings.

Question: The scanner works well otherwise, but for the line art, the lines

of which seem much thicker than those of the original.

Answer: Use the Brightness or Threshold setting to adjust the line art

image.

4-2

will not

noises, or it scans