Fujitsu ScanPartner 15C 사용자 설명서 - 페이지 22
{카테고리_이름} Fujitsu ScanPartner 15C에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ScanPartner 15C 26 페이지. Image scanner
Fujitsu ScanPartner 15C에 대해서도 마찬가지입니다: 사용자 설명서 (23 페이지), 사양 (2 페이지), 업그레이드 매뉴얼 (6 페이지), 소모품 교체 및 청소 지침 (7 페이지), 설치 절차 (5 페이지)
페이지 인쇄
Question: When I power on the scanner, it makes noises and
stand ready.
Answer: There are two possibilities:
a) You forgot to remove the shipping retainer from the scanner.
Please remove the shipping retainer first.
b) You did not place the scanner on a flat desktop surface. This
may cause the scanner to function improperly.
Question: When I power on the scanner, the lamp does not light.
Answer: The lamp is out of order. In that case, contact your authorized
local dealer to change the lamp. The life time of the lamp is
about 5000 hours.
Question: Getting image from the scanner is not a problem, but when
scanning, the scanner or system will often crash.
Answer: Please check
a) If the cable is firmly seated;
b) Only two SCSI terminators can be connected to your SCSI daisy
chain. One is at the end of the SCSI device, another is already in
your host adapter.
Question: While scanning, the scanner often makes
back and forth.
Answer: Please choose lower speed from the scanner setup for low speed
PC.
Question: The scanned image always comes out to be too dark.
Answer: Adjust scanner settings.
Question: The scanner works well otherwise, but for the line art, the lines
of which seem much thicker than those of the original.
Answer: Use the Brightness or Threshold setting to adjust the line art
image.
4-2
will not
noises, or it scans