Fujitsu ScanPartner 15C Gebruikershandleiding - Pagina 22

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Fujitsu ScanPartner 15C. Fujitsu ScanPartner 15C 26 pagina's. Image scanner
Ook voor Fujitsu ScanPartner 15C: Gebruikershandleiding (23 pagina's), Specificaties (2 pagina's), Upgrade handleiding (6 pagina's), Instructies voor vervanging en reiniging van verbruiksartikelen (7 pagina's), Installatieprocedures (5 pagina's)

Question: When I power on the scanner, it makes noises and

stand ready.

Answer: There are two possibilities:

a) You forgot to remove the shipping retainer from the scanner.

Please remove the shipping retainer first.

b) You did not place the scanner on a flat desktop surface. This

may cause the scanner to function improperly.

Question: When I power on the scanner, the lamp does not light.

Answer: The lamp is out of order. In that case, contact your authorized

local dealer to change the lamp. The life time of the lamp is

about 5000 hours.

Question: Getting image from the scanner is not a problem, but when

scanning, the scanner or system will often crash.

Answer: Please check

a) If the cable is firmly seated;

b) Only two SCSI terminators can be connected to your SCSI daisy

chain. One is at the end of the SCSI device, another is already in

your host adapter.

Question: While scanning, the scanner often makes

back and forth.

Answer: Please choose lower speed from the scanner setup for low speed

PC.

Question: The scanned image always comes out to be too dark.

Answer: Adjust scanner settings.

Question: The scanner works well otherwise, but for the line art, the lines

of which seem much thicker than those of the original.

Answer: Use the Brightness or Threshold setting to adjust the line art

image.

4-2

will not

noises, or it scans