- ページ 9

換気フード AEG 825 DのPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。AEG 825 D 20 ページ。 Cooker hood
AEG 825 D にも：据付・取扱説明書 (19 ページ), 操作およびインストール手順 (19 ページ)

Installation - Fig. 3

Put the template onto the wall (1) and drill two Ø12mm holes

(2).

Fit two hooks (3) on the drilled holes.

Hang the hood on the hooks and adjust the position of the

hood using the two screws on the bottom of the hooks (5).

Remove the metal filters (4) and mark two points (6).

Remove the hood and drill two Ø8mm holes on the marked

points.

Fit two Ø8mm wall dowels (7), Hang again the hood and fix

the hood definitively with two screws 5X45 (8).

Fix the chimney support (10) with two screws 5 x 45 mm (9)

and two wall dowels (11) on the wall close to the ceiling.

For exhausting version: Fit the connection ring (S) on the

top of the hood with two screws Ø 3,5 x 6,5 mm (12S) then

fit an exhausting pipe long enough to reach the outside

(13S).

For recycling version: Fix definitively the deflector (13K)

on the top of the hood with two screws Ø 3,5 x 6,5 mm

(12K).

Prepare the electric connection (14) (see relative chapter).

Fit the chimney (15) and fix it on the chimney support with

two screws 3,0 x 9 mm (16).

The lower part of the chimney must be slided down and

inserted on the housing on the upper part of the hood (18).

Fit the two grids (17) on both sides of the chimney.