- ページ 4

バスルーム設備 Kohler BodySpa K-1000のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Kohler BodySpa K-1000 28 ページ。 Tower custom hydro-massage system
Kohler BodySpa K-1000 にも：ホームオーナーズマニュアル (48 ページ)

ページを印刷する

4. BEFORE INSTALLING FOOTBATH

Install the drain to the footbath according to the drain

manufacturer's instructions. When installing the drain

overflow tube and hood, be sure to adequately seal along

the edges of the hood to prevent leakage.

5. INSTALL THE FOOTBATH

A. CONFIRM STUD POCKET ROUGH-IN

The door enclosure is specifically designed for this

footbath. For proper installation, make sure the double

studs for the wall jambs are in position before installing the

unit. Proper door enclosure assembly depends upon

installation of the footbath against square and plumb (to

within 3/8") studding. Verify this before proceeding with

the installation.

B. INSTALL THE FOOTBATH

The variable flow valve assembly is attached to the

suction line of the footbath harness for shipping, and

the wires are connected to the pump. Cut the

strapping, and remove the variable flow valve

assembly. Remove and discard the plug on the end

of the pump union. Then temporarily connect the

variable flow valve to the pump by loosely threading

the union nut to the pump discharge union.

Set the footbath on the subfloor. Align the trap with

the tailpiece.

Position a clean drop cloth in the footbath to prevent

damage.

Level the unit using the footbath rim surfaces. Do not

use the nailing-in flange to level the unit. The

footbath must be level to properly install and operate

the door enclosure.

Securely shim under the wood blocks as needed.

Secure the footbath to the studding using the

nailing-in flange and galvanized drywall screws. Drill

and countersink pilot holes halfway up the nailing-in

flange. Drill from the finished side of the nailing-in

flange to prevent chipping of the acrylic.

Add furring strips to the stud framing inside the

recess area. This will make the studs even with the

footbath nailing-in flange.

116290-2-

Variable Flow

Valve Assembly

Pump

Nailing-In

Flange

Kohler Co., Kohler WI U.S.A.