- ページ 2

温度コントローラー Aqua Logic DC115S-20のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Aqua Logic DC115S-20 4 ページ。 Dc series single stage digital temperature control

ページを印刷する

Temperature Controller Set-up

This digital controller has been pre-programmed with all the

necessary parameters to ensure reliable service and operation. The

controller is pre-set from the factory with a temperature range from

30 °F to 100 °F with a display resolution of 1 degree °F and with a

1 °F temperature differential.

Temperature Controller Setpoint Set-up

To modify the set point* temperature.

Press and release the "SET" button. SP

will be displayed. Press the "SET" button

again and the pre-programmed set point

temperature will be displayed. Press the

up arrow ▲ to increase or the down

arrow ▼ to decrease the set point.

Once the desired set point value has

been selected, do not touch any of the

keys for 1 minute or press the "SET" and

the "DOWN" ▼ arrow at the same time.

The control will then revert to displaying

the current water temperature, but will

now control the water temperature to the

desired set point.

This indicates that the chiller or heater should be energized.

Temperature Differential:

When the water has reached the set point temperature, the chiller or

heater will switch off and will not switch back on until the water

temperature has changed by 1 °F. This value is known as the

temperature differential between on and off cycles. Refer to the

temperature control parameters table to change the settings.

Limited Warranty

This controller has a one (1) year limited warranty.

Aqua Logic, Inc. warrants this temperature controller to be free of

defects in materials or workmanship for a period of one (1) year from

the date of purchase. In the event of a defect or failure of this product,

RETURN THE CONTROLLER WITH PROPER PACKAGING along

with pre-authorized issued RMA number, proof of purchase and / or a

copy of the original bill of sale to the address below, freight prepaid.

COD shipments will be refused. After inspection, to ascertain that

there is a defect due to material or workmanship and that the product

is still under warranty, Aqua Logic will repair or replace the product at

our discretion and return ship the unit, Our liability is limited to the

cost of defective materials. In no case will Aqua Logic assume liability

for consequential damage resulting from any failure. Not covered by

this warranty are damage due to corrosion, abuse, accidental,

alterations, unreasonable or improper use. Aqua Logic is not liable for

payment or field repair work without prior written authorization.

Call or email Aqua Logic for a RMA number.

PH: 858.292.4773

email to: [email protected]

Return the controller to this address below with a copy of the RMA

inside the box within 30 days to:

Aqua Logic, Inc.

Attn: Return Dept. RMA# (put your number here)

9558 Camino Ruiz.

San Diego, CA. 92126