- ページ 2
配管製品 Billi 926065のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Billi 926065 7 ページ。 Dispenser options: xl and mixer tap, al
Billi 926065 にも： ユーザーマニュアル (9 ページ)
ページを印刷するCONTENTS
Contents
2
Warnings and Important Information
- For continued safety of this appliance, it must be installed, operated and maintained in accordance with the manufacturer's instructions.
2
- Your appliance should be installed by the manufacturer, a service agent, or any other suitably qualified tradesperson.
3
- For correct operation of this appliance it is essential to observe the instructions as outlined in this booklet.
4
- Do not use this appliance with water that is microbiologically unsafe or with water of unknown quality without adequate disinfection before
4
or after the system. Systems certified for cyst reduction may be used on disinfected water that may contain filterable cysts.
4
- Filter replacement must be performed at intervals of not more than 12 months.
5
- Use this appliance only as directed in these instructions and only for its designed purpose.
7
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or persons
with lack of experience and knowledge, unless they are supervised or have been given instruction concerning use by a person responsible
9
for their safety.
11
- This appliance is not to be installed in an area where a water jet could be used.
12
- Children should be supervised to ensure that they do not play with the appliance.
- DANGER: The operation of the internal thermal cut-out indicates a possibly dangerous situation. Do not reset the thermal cut-out until the
appliance has been serviced by a suitably qualified person.
- WARNING: Do not connect any restrictor, pressure relief device or non-return valve to the vent pipe of this appliance.
- WARNING: When positioning the appliance ensure the power supply cord is not trapped or damaged.
- WARNING: Do not install the appliance using a power board, double power adaptor or any other similar device. The appliance is to be
plugged directly into a suitably protected and rated power point.
- WARNING: If the power supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons.
The appliance is not to be used until the power supply cord is repaired.
- WARNING: Avoid spillages of any kind on all electrical connectors.
- WARNING: Potential injury can result from misuse.
- WARNING: Internal surfaces adjacent to and directly in contact with the heating element are subject to residual heat after use.
- Only Billi hose and tube kits as supplied with the appliance are to be used. Old or other manufacturer's hose and tube kits should not
be used.
- WARNING: This appliance may deliver water at high temperature. Refer to the plumbing code of Australia (PCA), local requirements and
installation instructions to determine if additional temperature control is required.
- WARNING: Installation shall conform to the plumbing code of Australia (PCA) or relevant local requirements.
- If the appliance is installed in a location where the ambient air temperature could fall below 4°C, do not turn off power to the appliance to
prevent malfunction. This safeguard does not offer protection to connecting pipework and fittings external to the appliance.
- The appliance is designed to operate in an ambient air temperature range of 5°C to 30°C.
- Turn off power to the appliance by unplugging the power cord from the connected power point. Only do so after the inlet water supply has
been turned off.
- The appliance is intended to be used in household and similar applications such as:
• Staff kitchen areas in shops, offices, and other working environments.
• By clients in hotels, motels, and other residential type environments.
• Bed and breakfast type environments.
• Catering and similar non-retail applications.
- Please note maximum inlet water pressure is 1000kPa.
3