- ページ 7

サーバー Dell 3250のPDF 情報更新をオンラインで閲覧またはダウンロードできます。Dell 3250 32 ページ。 Product guide (.pdf)
Dell 3250 にも：製品マニュアル (37 ページ), オーナーズマニュアル (39 ページ), オーナーズマニュアル (39 ページ), クイック・スタート・マニュアル (2 ページ)

Ta b l e 1 - 3 .

S C S I H a r d - D r i v e S t a t u s I n d i c a t o r C o d e s ( c o n t i n u e d )

Indicator

Blinks green twice per second at equal

intervals

Blinks green twice per second at unequal

intervals

Blinks amber 4 times per second

Blinks green, then amber, and then off,

repeating this sequence every 2 seconds

Steady green

NOTE: The drive busy indicator identifies whether the hard drive is active on the SCSI bus. This

indicator is controlled by the hard drive.

Intel Server Management Software Options

The Lock Front Panel option does not change the status of the SD/INT button. This

button cannot be locked out.

After changing the system's IP address, you must reboot the system. The Intel Server

Management software will not be available until you reboot the system.

If you are using a RAID controller card with the Red Hat Linux operating system, you must

update the megaraid driver. Two methods for updating this driver are described below.

From the operating system, you may install the megaraid driver rpm from the Dell

PowerEdge 3250 PERC 4/DC CD. The megaraid driver rpm is also available on

support.dell.com. Perform the following steps to install the rpm:

Type cd /mnt/cdrom/RedHat/RPMS.

Install the megaraid driver rpm by typing the following command:

rpm -ivh --force megaraid-1.18f-1.ia64.rpm

Reboot your system to use this driver.

Indicator Code

Drive being prepared for removal

Drive rebuilding

Drive failed

Predicted failure for the drive

Drive online

Inf o r mat io n Updat e

1-3