- ページ 16

サーバー Dell PowerEdge 2650のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge 2650 26 ページ。 Activating the integrated raid controller
Dell PowerEdge 2650 にも：インストールマニュアル (32 ページ), 情報更新 (14 ページ), インストレーション・マニュアル (20 ページ), インストールマニュアル (40 ページ), 交換マニュアル (28 ページ), 取扱説明書 (8 ページ), マニュアル (42 ページ), マニュアル (15 ページ), マニュアル (42 ページ)

1-8

Rack Installation Guide

Installing the Slide Assemblies in the Rack

NOTE: If the slide assemblies were preinstalled by Dell, you can skip this section.

You must allow 2 U (3.5 inches) of vertical space for each system you install in the

rack.

NOTE: The vertical rails of the rack are marked by small indentations in 1-U

increments (see Figure 1-6).

1 U (1.75 inches)

Figure 1-6. One Rack Unit

For more information about requirements for installing components in a Dell rack, see

the Dell Rack Advisor software available on the Dell Web site at

http://support.dell.com.

CAUTION: If you are installing more than one system, install the slide

assemblies so that the first system is installed in the lowest available posi-

tion in the rack.

To install the slide assemblies in the rack, perform the following steps:

Place the front of the template on the vertical rails at the front of the rack where

you want to install the system.

Ensure that the printing on the template identifies the side facing outward as the

template front.