Dell PowerEdge 2650 Instrukcja instalacji - Strona 16

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Serwer Dell PowerEdge 2650. Dell PowerEdge 2650 26 stron. Activating the integrated raid controller
Również dla Dell PowerEdge 2650: Instrukcja instalacji (32 strony), Aktualizacja informacji (14 strony), Instrukcja instalacji (20 strony), Instrukcja instalacji (40 strony), Instrukcja wymiany (28 strony), Instrukcja obsługi (8 strony), Podręcznik (42 strony), Podręcznik (15 strony), Podręcznik (42 strony)

1-8

Rack Installation Guide

Installing the Slide Assemblies in the Rack

NOTE: If the slide assemblies were preinstalled by Dell, you can skip this section.

You must allow 2 U (3.5 inches) of vertical space for each system you install in the

rack.

NOTE: The vertical rails of the rack are marked by small indentations in 1-U

increments (see Figure 1-6).

1 U (1.75 inches)

Figure 1-6. One Rack Unit

For more information about requirements for installing components in a Dell rack, see

the Dell Rack Advisor software available on the Dell Web site at

http://support.dell.com.

CAUTION: If you are installing more than one system, install the slide

assemblies so that the first system is installed in the lowest available posi-

tion in the rack.

To install the slide assemblies in the rack, perform the following steps:

Place the front of the template on the vertical rails at the front of the rack where

you want to install the system.

Ensure that the printing on the template identifies the side facing outward as the

template front.