- ページ 33
スイッチ Dell Force10 S55のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 S55 50 ページ。
Dell Force10 S55 にも： クイック・スタート・マニュアル (29 ページ)
ページを印刷する
Access the console ports
The S55 system can be accessed directly through the console port at I/O side of the switch.
Access the RJ45 console port (RS-232)
NOTE: Before starting this procedure, be sure you have a terminal emulation program already installed on
your PC.
The RS-232 console port is labeled on the S55 chassis. It is in the upper right-hand side, as you face the
I/O side of the chassis.
Figure 7-1. S55 serial console port connector
RJ-45
Console Port
To access the console port, follow the procedures below. Refer to
Step
Task
Install an RJ-45 copper cable into the console port. Use a rollover cable to connect the S55 console port to a
1
terminal server.
Connect the other end of the cable to the DTE terminal server.
2
Default terminal settings on the console are set as follows:
3
• 9600 baud rate
• No parity
• 8 data bits
• 1 stop bit
• No flow control
Table 7-1
for the console port pinout.
Access the console ports
7
|
33