Dell Force10 S55 매뉴얼 - 페이지 33

{카테고리_이름} Dell Force10 S55에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S55 50 페이지.
Dell Force10 S55에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (29 페이지)

Access the console ports

The S55 system can be accessed directly through the console port at I/O side of the switch.

NOTE: Before starting this procedure, be sure you have a terminal emulation program already installed on

your PC.

The RS-232 console port is labeled on the S55 chassis. It is in the upper right-hand side, as you face the

I/O side of the chassis.

Figure 7-1. S55 serial console port connector

RJ-45

Console Port

To access the console port, follow the procedures below. Refer to

Step

Task

Install an RJ-45 copper cable into the console port. Use a rollover cable to connect the S55 console port to a

terminal server.

Connect the other end of the cable to the DTE terminal server.

Default terminal settings on the console are set as follows:

• 9600 baud rate

• No parity

• 8 data bits

• 1 stop bit

• No flow control

Table 7-1

for the console port pinout.

Access the console ports