- ページ 14
溶接システム Miller Axcess 300のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller Axcess 300 36 ページ。 Arc welding power source and wire feeder with meters
Miller Axcess 300 にも： オーナーズマニュアル (44 ページ), オーナーズマニュアル (48 ページ)
ページを印刷する
2-3. Volt-Ampere Curve
2-4. Installing Work Clamp
OM-1317 Page 10
5
1
2
3
1
Normal Volt-Ampere Curves
The volt-ampere curves show the
normal minimum and maximum
voltage and amperage output capa-
bilities of the welding power source.
Curves of other settings fall be-
tween the curves shown.
2
Overload Volt-Ampere Curves
When unit is used beyond capacity,
circuitry senses the overload and
shuts down unit output. Release
trigger and lower weld voltage set-
ting before trying to weld. This shut
down circuitry protects internal
circuits and parts from overload
damage.
1
Work Cable
2
Boot
Slide boot onto work cable. Route
cable out front panel opening from
inside.
3
Negative (–) Output Terminal
Connect cable to terminal and
cover connection with boot.
4
4
Hardware
5
Work Clamp
Route cable through clamp handle
and secure as shown.
Close door.
Tools Needed:
1/2, 3/4 in
ST-185 560
ST-801 955