- ページ 12
蒸発器 dicodes Dani Box V2のPDF マニュアルをオンラインで閲覧またはダウンロードできます。dicodes Dani Box V2 18 ページ。
ページを印刷する
06 Extended Functions Menu (Page 1: Overview)
Change wire
temperature
coefficient of
"Other" wire (*1)
Default 320
Set Power Limit
(80Wmax.)
Default 80W
Select heater
protection mode
(1..10)
Default 6
Select power
boost time
(1..10)
Default 3
Select power
boost power
(1..10)
Default 50W
Only visible when
Expert Mode =1
(*1 ) The temperature coefficient selects the type of wire material in the range 050 to 650: When TC-mode is
selected (Main menu HCtrl=1), the user must select the wire type to be NiFe30 (320, dicodes wire), Ni200 (620),
Titanium (350), SS304 (105, V2A), SS316 (88), SS316L (92), NiFe48 (480) or "Other". The value for "Other" is
adjusted here. Value to select = Literature-value*10E5 K. Example: Ni 6.2E-3*1/K * 10E5*K => 620
(*2 ) Setting 1 (fastest) up to3 without animation (visual shift effect), setting 4 slowest with shift animation
(*3 ) When temperature controlled vaping mode is selected and with diplay mode=post/cont, the current values of
"Power", "Temperature" and "Wire-Resistance" can be observed 4 seconds after/during the vape. In power
mode, the battery voltage, power and resistance is displayed. In Bypass mode the measured power is displayed.
With display mode = off no parameters are displayed after or during the vape
Set the minimum bat
discharge level
(2.5..3V)
Default 2.7V
Set display luminosity
(1 low to 5 high
brightness)
Default 4
Select auto power
off time (1-2-5-10-15-
20-30-60 minutes)
Default 5min.
Select number of clicks
to get into the menu
(1..5).
Default 1
Speed for button
usage (1 fast..5 slow).
(*2 )
Default 3
Selects temperature
unit either °Celsius or
°Fahrenheit.
Default °C
Parameter display
during vape
off/post/cont (*3)
Default cont
Select display
orientation between
Left and Right (handed)
Default R
Wrap around
(roll over or stop
at min/max)
Default 1
Select Expert mode to
enable power boost,
heater protection and
bypass mode.
Default 0
Switch back all settings
to factory defaults
Counts the number of
puffs since last counter
reset.
Displays pure vaping
time in H:MM:SS since
last counter reset
Energy taken from
battery during vaping
since last counter reset
Displays battery
capcitance since last
counter reset (can
show battery quality)
Reset the counters
above.
Total lifetime puffs
of mod.
Not resettable.
Total lifetime vaping
time of mod in
HHHH:MM
Not resettable.