- ページ 13

蒸発器 dicodes Dani Box V2のPDF マニュアルをオンラインで閲覧またはダウンロードできます。dicodes Dani Box V2 18 ページ。

06 Extended Functions Menu

Additional Explanation to several menu items, page 1

In the following paragraphs, explanations are given for those parameters and items, which are not self

explanatory or which have inter-dependencies with other parameters or functions.

The selection of the correct wire-temperature-coefficient is very important for the

correct operation of the mod, when temperature controlled vaping is selected.

As soon as TC-mode is selected, a multiple choice list of commonly used wires types

with predefined coefficients is displayed and the wire type "Other".

The coefficient of this "Other" wire is adjusted in this menu item. Note that stainless steel wires and also

titanium wires often have not well defined coefficients, depending on their exact alloy composition.

The TCoef item in the menu is visible, even if the operation mode is not selected to temperature

controlled vaping.

Power Limit defines the adjustment range of the power in the main menu. As stated

in the main menu already, the limit value sets the roll-over or stop point of the menu

"Power". The power limitation makes sense especially in the power vaping mode to

reduce the range to the used atomizer.

All dicodes devices have a functionality to adjust the minimum discharge level of the

battery between 2.5V and 3.0V (older models 3.5V). Almost all available batteries on

the market specify the minmum discharge level of 2.5V to 2.7V. If the user is unsure

whether her/his specific battery meets this specification, the level should be set to 2.7V.

The selected voltage is the

voltage at the electronics

input, when current is

drained from the battery

(Ub,L). In contrast to other

available tube- and box-

mods on the market, which

stop operation already at

3.4V, the lower discharge

level on dicodes mods

lead to a better battery

utilization.

At UBatMin+ 0.7V a power reduction is activated depending on the actual power setting. The reduction

starts when the power selected hits the slope from Ubat,min@10W to Ubat,min+0.7V@80W as show

in the diagram above.

The time to automatic power off of the mod can be selected between 1 minute up to

60 minutes. We recommend to choose 1 or 2 minutes, because the mod is always

immediately on and ready to vape, when the fire button is pressed. This provides

the best utilization of the battery. When off, the device draws zero current from the

battery.

Note that if the mod was actively switched off by the user (5 times fast clicking of the fire button), the

instant power on is not available. In this case the mod has to be switched on with 5 clicks first.