- ページ 7

バッテリーチャージャー AXITEC AXIbox 11KのPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。AXITEC AXIbox 11K 13 ページ。

Installationsanleitung AXIbox 11K

5 Requirements

When making the electrical connection, the country-specific regulations, standards and application rules

must be observed.

The power supply of the wallbox must be three-phase (3P + N + PE; min. 5 x 2,5 mm

, depending on the

locally applicable regulations, environmental conditions and installation type). The required conductor

voltage is 400 V AC and a current of 16 A per phase with 50 Hz mains frequency.

The phases of the supply line must each be protected with miniature circuit breakers and residual current

devices. The national regulations must be observed when dimensioning the miniature circuit breakers and

residual current devices.

The AXIbox 11K has residual current monitoring for currents >6 mA DC. Therefore, the charging station

must be fused with an RCD with at least type A. No other circuits may be connected to the residual current

circuit breaker.

To control the AXIbox with the app, a W-Lan connection with 2.4 GHz is required at the installation site.

The AXIbox may only be mounted and operated vertically.

Mounting is permitted up to a maximum altitude of 2000 m above sea level.

The ambient temperature must not fall below -30°C and must not exceed 50°C.

The humidity must be in the range between 5% and 95%.

Do not install the charging station near explosive or flammable substances.

EN211103