- ページ 7

顕微鏡 Olympus BH2 SeriesのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Olympus BH2 Series 9 ページ。 Phase contrast
Olympus BH2 Series にも：トラブルシューティング＆調整マニュアル (46 ページ), 完全な分解、洗浄、再組み立て (23 ページ), 完全な分解、洗浄、再組み立て (40 ページ), 分解、清掃、再組み立て (45 ページ), マニュアル (6 ページ)

2021/10/12 04:32

the clamp on side of the microscope.

Position back plate so that vertical adjustment screws are midway in slots

Use the 5/64" Allen Wrench to tighten the Base plate clamp at a point where the vertical adjustment

screws are midway in the slots

After securing the back plate check for proper drive alignment be rotating the right ﬁne focus knob.

The drive is usually self aligning and when properly aligned no drag is felt, other then that caused by

the gears, while rotating the ﬁne focus knob. When the dive is in a position of proper alignment use

the 5/32 Allen wrench to tighten the horizontal, and vertical adjustment screws at the position where

minimum drag is felt.

Recheck for minimum drag on the ﬁne focus shaft by turning the right ﬁne focus knob. If there is any

drag felt at any particular point while rotating the right ﬁne focus knob repeat the alignment

procedure by loosening the horizontal, and vertical adjustment screws and repositioning the drive.

The drive is usually self aligning , and if realignment is necessary loosen the horizontal, and z vertical

adjustment screws and move the drive so that is slides into its natural position and then tighten the

Applied Scientiﬁc Instrumentation - https://asiimaging.com/docs/

7/9

Olympus BH-2 Microscope Motor Drive Installation