- ページ 8

計測機器 Accurate Technology Digi Scale Model 20のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Accurate Technology Digi Scale Model 20 17 ページ。

Shortening Scales

To shorten Digi Scale follow these steps:

The scale has stainless-steel wires pressed into the side that could be damaged if not

cut properly.

1. Clamp the wires so they do not pull away from the extrusion.

2. Using a hacksaw, cut through the aluminum extrusion.

3. Use a file or sanding tool to chamfer the cut end to approximately the

specifications shown in the illustration.

4. Remove all burrs.

5. Test the shortened scale by sliding a Encoder on. There should not be any

binding.

Wires

Accurate Technology Digi Scale

.07" (2mm)

.25" (6mm)

Wires

Page 8 of 17