Accurate Technology Digi Scale Model 20 Kullanıcı Kılavuzu - Sayfa 8

Ölçüm Cihazları Accurate Technology Digi Scale Model 20 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Accurate Technology Digi Scale Model 20 17 sayfaları.

Sayfayı Yazdır

Shortening Scales

To shorten Digi Scale follow these steps:

The scale has stainless-steel wires pressed into the side that could be damaged if not

cut properly.

1. Clamp the wires so they do not pull away from the extrusion.

2. Using a hacksaw, cut through the aluminum extrusion.

3. Use a file or sanding tool to chamfer the cut end to approximately the

specifications shown in the illustration.

4. Remove all burrs.

5. Test the shortened scale by sliding a Encoder on. There should not be any

binding.

Wires

Accurate Technology Digi Scale

.07" (2mm)

.25" (6mm)

Wires

Page 8 of 17