- ページ 4

スプレッダー Cresco 15SWのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cresco 15SW 16 ページ。 Fertilizer and salt spreader

Assembling your Cresco 25

Place the Hopper body (1) on the table so that the

gearbox is pointing upwards. Take the bolts out of

the main frame (1) - you will use these to attach

the backstand to the hopper body and main frame

(1). Remove the nuts from the bolt ends.

Use a spanner to tighten the lock nuts. The

backstand (5) should now be securely attached

to the hopper body and frame. (1).

Align the hole on the inside of the pneumatic

wheel (2) with the hole on the axle. Take the

large cotterpin (9) and thread it through the two

holes.

Take the backstand (5) and align it with the

holes on the main frame (1). Place the four bolts

through the holes available.

Take the pneumatic wheels (2) and slide them

over the axles on each side of the main frame

(1). You will also need the two cotter pins (8 & 9)

that sit inside the parts bag.

After threading the cotter pin (9) through the two

holes, use a pair of plyers to pull apart the two

ends of the cotter pin (9). The wheel will then be

secured in place.