- ページ 10
釣具 Shimano DENDOUMARU 4000HPのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Shimano DENDOUMARU 4000HP 32 ページ。
ページを印刷する
Supplied
10 m line
More than
3 sec.
3
Connect the end of the line already
wound to the supplied 10m line.
4
After positioning in the physical
relationship of the figure, press the
MEMO/0 SET button for 3 sec. or more
once the winding has been fully
completed.
The display will be as shown above.
10
Beep beep
Connect
More than
3 sec.
10~20cm
5
Wind the newly connected 10M line
manually.
The RPM is shown one step lower.
To end Learning, press the Memo, 0-
setting button for more than 3 seconds.
"セット (Set)" will appear.
take while the input is being done, the data
half-done will all be cancelled. In that case,
pull out the line, and re-do from Step
Beep beep
About 10cm
If the mode switch is pressed by mis-
6
The display returns to Top Mode.
(The figure from the counter and the actual
line length may differ by a max. of 3%.)
7
Wind up the 10M line that has been
pulled out.
Precautions: When winding line such as
Nylon, the inaccuracies of counter may
exceed 3%.
1
.
Note: Learning inaccuracy may result
in count error.