- ページ 4

産業機器 Siemens SIREMOBIL Iso-CのPDF 設置・設定マニュアルをオンラインで閲覧またはダウンロードできます。Siemens SIREMOBIL Iso-C 6 ページ。
Siemens SIREMOBIL Iso-C にも：取り付けとセッティングの説明 (4 ページ), 取扱説明書 (16 ページ), メンテナンス方法 (46 ページ), 取付説明書 (6 ページ)

ページを印刷する

If a multiformat camera is not connected

Power cable

Videoprinter with 100VAC line voltage:

Connect the line wires to transformer T1, connector TI - 34 and TI - 36.

Connect the protective conductor to the protective conductor terminal stripe (ye/gn).

Videoprinter with 120VAC line voltage:

Connect the line wires to transformer T1, connector TI - 35 and TI - 36.

Connect the protective conductor to the protective conductor terminal stripe (ye/gn).

Videoprinter with 230VAC line voltage:

•

Connect the line wires of the video printer at terminals X2.1 and X2.2.

•

Connect the protective conductor at the corresponding location (yellow/green).

•

Route the line wires to the video printer compartment.

Hardcopy exposure control cable

•

Connect the control cable included with the shipment at the Memoskop "Printer"

connector.

•

Route the end of the cable with the 3.5 mm jack plug to the video printer compartment.

Video cable

•

Connect the video cable at the Memoskop "Out3" connector.

•

Route the video cable to the video printer compartment.

•

Connect the video printer. Ensure the proper termination of the video cable

(75 ohm).

Programming

For Memoskop C (with keyboard)

•

Switch on the system.

•

Press [CTRL] and [U] simultaneously on the Memoskop keyboard.

•

Call up the "C Documentation" sub-menu.

•

Perform the configuration on monitor A for SIREMOBIL Iso-C systems with one monitor.

•

Perform the configuration on monitor B for SIREMOBIL Iso-C systems with two monitors.

•

If the system is equipped with an area dose measurement device (Diamentor), call up

the "K documentation of the dose" sub-menu and configure to "yes".

•

End the "User menu".

SIREMOBIL Iso-C

This calls the "User Setup menu" for Memoskop.

Installing a Video Printer

SPR2-230.033.02

Rev. 02

10.99

Page 4 of 6

TD SD 24

Medical Engineering

Siemens AG