- ページ 30

産業機器 Siemens SIWAREX WL230 BB-S SAのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Siemens SIWAREX WL230 BB-S SA 48 ページ。 Base plate and elastomer bearing bb-s sa
Siemens SIWAREX WL230 BB-S SA にも：マニュアル (36 ページ), 設備マニュアル (50 ページ), 取扱説明書 (44 ページ)

ページを印刷する

Installation

5.2 Installing the base plate and elastomeric bearing

5.2.8

Install the load cell with elastomeric bearing unit

Safety guidelines

Death or serious bodily injury

A falling load bearing implement can lead to serious bodily injury or considerable material

damage depending on the potential risk.

Personal injuries, damage to the load cells

Insufficiently secured loads can fall and cause injuries or material damage. Therefore,

appropriate lifting tools must be used to lift the load bearing implement. The corresponding

safety regulations must be observed.

NOTICE

Damaging of load cells

Incorrect or incomplete installation can result in damage to the load cells, installed parts

and the load bearing implement.

Observe the warning notices at the start of the chapter, see: Safety information/instructions

(Page 23)

NOTICE

Damage of the load cells and the elastomeric bearing

• Check that the load cells and installation unit are installed correctly, e.g. by checking the

• Ensure that the cable does not become damaged or is cut off.

• Lay the cables through cable glands in the form of a vertical downwards loop to

Installation requirements

● Flatness of the mounting surfaces: The flatness of mounting surface planes must be

≤ 0.2 mm.

● Compressive strength of the mounting surfaces: The compressive strength of the

mounting surfaces has to be appropriate for the contact surface pressure of the base

plate and elastomeric bearing.

WARNING

CAUTION

mounting dimensions and oscillation distances. Incorrect assembly can result in damage

to the load cell and the installation unit.

discourage the penetration of water.

Operating Instructions, 03/2013, A5E31529044A-01

SB-S SA