- ページ 3

ネットワーク・ルーター Cisco 1751のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 1751 35 ページ。 Modular access router
Cisco 1751 にも：ソリューションの概要 (16 ページ), データシート (19 ページ)

ページを印刷する

Figure 1

VIC

E&M

You should install and cable VICs before performing the software configuration tasks explained later in

this guide.

Be sure to observe all warnings and safety precautions in the installation guide.

Warning

Caution

VICs do not support online insertion and removal (hot swap). To avoid equipment damage, turn off

electrical power and disconnect network cables before you insert a VIC in the router.

WIC and VIC Installation Procedure

Follow these steps, and refer to

Step 1

Make sure the router is turned off and is disconnected from the power supply.

Step 2

Loosen the thumbscrews on the WIC or VIC slot cover on the rear panel.

You should be able to loosen the screws using your fingers; however, if the screws are very tight, you

might need to use a Phillips screwdriver.

Step 3

Remove the metal plate that covers the card slot.

Step 4

Hold the card by the edges on either side of the card front panel, and line up the card edges with the

guides inside the card slot, as shown in

Step 5

Insert the card in the slot and gently push it into the router until the front panel of the card is flush with

the rear panel of the router.

Step 6

Tighten the screws.

78-11259-05

Voice Interface Card

VIC ports

SEE MANUAL BEFORE INSTALLATION

Figure 2

to insert a WIC or a VIC in the router:

Figure

Cisco 1751 Voice-over-IP Quick Start Guide

Installing WAN and Voice Interface Cards