Cisco 1751 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Cisco 1751에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1751 35 페이지. Modular access router
Cisco 1751에 대해서도 마찬가지입니다: 솔루션 개요 (16 페이지), 데이터시트 (19 페이지)

페이지 인쇄

Figure 1

VIC

E&M

You should install and cable VICs before performing the software configuration tasks explained later in

this guide.

Be sure to observe all warnings and safety precautions in the installation guide.

Warning

Caution

VICs do not support online insertion and removal (hot swap). To avoid equipment damage, turn off

electrical power and disconnect network cables before you insert a VIC in the router.

WIC and VIC Installation Procedure

Follow these steps, and refer to

Step 1

Make sure the router is turned off and is disconnected from the power supply.

Step 2

Loosen the thumbscrews on the WIC or VIC slot cover on the rear panel.

You should be able to loosen the screws using your fingers; however, if the screws are very tight, you

might need to use a Phillips screwdriver.

Step 3

Remove the metal plate that covers the card slot.

Step 4

Hold the card by the edges on either side of the card front panel, and line up the card edges with the

guides inside the card slot, as shown in

Step 5

Insert the card in the slot and gently push it into the router until the front panel of the card is flush with

the rear panel of the router.

Step 6

Tighten the screws.

78-11259-05

Voice Interface Card

VIC ports

SEE MANUAL BEFORE INSTALLATION

Figure 2

to insert a WIC or a VIC in the router:

Figure

Cisco 1751 Voice-over-IP Quick Start Guide

Installing WAN and Voice Interface Cards