Cisco 1751 Краткое руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Сетевой маршрутизатор Cisco 1751. Cisco 1751 35 страниц. Modular access router
Также для Cisco 1751: Обзор решений (16 страниц), Информационный лист (19 страниц)
Печатать страницу
Figure 1
VIC
E&M
You should install and cable VICs before performing the software configuration tasks explained later in
this guide.
Be sure to observe all warnings and safety precautions in the installation guide.
Warning
Caution
VICs do not support online insertion and removal (hot swap). To avoid equipment damage, turn off
electrical power and disconnect network cables before you insert a VIC in the router.
WIC and VIC Installation Procedure
Follow these steps, and refer to
Step 1
Make sure the router is turned off and is disconnected from the power supply.
Step 2
Loosen the thumbscrews on the WIC or VIC slot cover on the rear panel.
You should be able to loosen the screws using your fingers; however, if the screws are very tight, you
might need to use a Phillips screwdriver.
Step 3
Remove the metal plate that covers the card slot.
Step 4
Hold the card by the edges on either side of the card front panel, and line up the card edges with the
guides inside the card slot, as shown in
Step 5
Insert the card in the slot and gently push it into the router until the front panel of the card is flush with
the rear panel of the router.
Step 6
Tighten the screws.
78-11259-05
Voice Interface Card
VIC ports
1
SEE MANUAL BEFORE INSTALLATION
Figure 2
0
to insert a WIC or a VIC in the router:
Figure
2.
Cisco 1751 Voice-over-IP Quick Start Guide
Installing WAN and Voice Interface Cards
3