- ページ 7

ネットワーク・ルーター Cisco 1811のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 1811 11 ページ。 Integrated services router cabling and installation
Cisco 1811 にも：データシート (16 ページ), クイック・スタート・マニュアル (11 ページ)

ページを印刷する

• 9600 baud

• 8 data bits

• No parity bits

• 1 stop bit

The Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide describes how to configure the router

by using Cisco IOS software.

Follow these steps to connect the router to a terminal or PC:

Connect the RJ-45 end of the console cable to the CONSOLE port on the back panel of the router, as shown in Figure 4.

Step 1

Figure 4

Connecting the Console Cable to the Router

To PC

or Terminal 1

Connect the DB-9 end of the console cable to the console port (also called the serial port) on your PC. If this adapter

Step 2

does not fit your PC console port, you must provide an adapter that fits.

Verifying Your Installation

You can verify that you have correctly installed your router by checking the LEDs as described in Table 1.

Table 1

LEDs That Verify Installation

LED

Meaning

SYS OK

Steady green—Router has successfully booted up and the software is functional.

Blinking green—Router is booting or in ROM monitor mode.

POE

Off—Inline power supply not installed.

Steady green—Inline power supply OK.

Amber—Power denied.

FE 0–9

Steady green—Ethernet link is established.

Blinking green—Activity on the Ethernet link.

Off—No link.

Steady green—Modem connection established (carrier detect).

Off—No connection established.

SPD

Steady green—Connection at high speed (V.90).

Off—Connection at low speed (V.32/V.32b/V.34).

BUSY

Blinking green—Activity over modem line.

Off—No activity.