Cisco 1811 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} Cisco 1811에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1811 11 페이지. Integrated services router cabling and installation
Cisco 1811에 대해서도 마찬가지입니다: 데이터시트 (16 페이지), 빠른 시작 매뉴얼 (11 페이지)

페이지 인쇄
Cisco 1811 빠른 시작 매뉴얼
• 9600 baud
• 8 data bits
• No parity bits
• 1 stop bit
The Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide describes how to configure the router
by using Cisco IOS software.
Follow these steps to connect the router to a terminal or PC:
Connect the RJ-45 end of the console cable to the CONSOLE port on the back panel of the router, as shown in Figure 4.
Step 1
Figure 4
Connecting the Console Cable to the Router
To PC
or Terminal 1
Connect the DB-9 end of the console cable to the console port (also called the serial port) on your PC. If this adapter
Step 2
does not fit your PC console port, you must provide an adapter that fits.
8

Verifying Your Installation

You can verify that you have correctly installed your router by checking the LEDs as described in Table 1.
Table 1
LEDs That Verify Installation
LED
Meaning
SYS OK
Steady green—Router has successfully booted up and the software is functional.
Blinking green—Router is booting or in ROM monitor mode.
1
POE
Off—Inline power supply not installed.
Steady green—Inline power supply OK.
Amber—Power denied.
FE 0–9
Steady green—Ethernet link is established.
Blinking green—Activity on the Ethernet link.
Off—No link.
2
CD
Steady green—Modem connection established (carrier detect).
Off—No connection established.
2
SPD
Steady green—Connection at high speed (V.90).
Off—Connection at low speed (V.32/V.32b/V.34).
2
BUSY
Blinking green—Activity over modem line.
Off—No activity.
7