Cisco 1811 Краткое руководство по эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Сетевой маршрутизатор Cisco 1811. Cisco 1811 11 страниц. Integrated services router cabling and installation
Также для Cisco 1811: Информационный лист (16 страниц), Краткое руководство по эксплуатации (11 страниц)
Печатать страницу
• 9600 baud
• 8 data bits
• No parity bits
• 1 stop bit
The Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide describes how to configure the router
by using Cisco IOS software.
Follow these steps to connect the router to a terminal or PC:
Connect the RJ-45 end of the console cable to the CONSOLE port on the back panel of the router, as shown in Figure 4.
Step 1
Figure 4
Connecting the Console Cable to the Router
To PC
or Terminal 1
Connect the DB-9 end of the console cable to the console port (also called the serial port) on your PC. If this adapter
Step 2
does not fit your PC console port, you must provide an adapter that fits.
8
Verifying Your Installation
You can verify that you have correctly installed your router by checking the LEDs as described in Table 1.
Table 1
LEDs That Verify Installation
LED
Meaning
SYS OK
Steady green—Router has successfully booted up and the software is functional.
Blinking green—Router is booting or in ROM monitor mode.
1
POE
Off—Inline power supply not installed.
Steady green—Inline power supply OK.
Amber—Power denied.
FE 0–9
Steady green—Ethernet link is established.
Blinking green—Activity on the Ethernet link.
Off—No link.
2
CD
Steady green—Modem connection established (carrier detect).
Off—No connection established.
2
SPD
Steady green—Connection at high speed (V.90).
Off—Connection at low speed (V.32/V.32b/V.34).
2
BUSY
Blinking green—Activity over modem line.
Off—No activity.
7