- ページ 15

ネットワーク・ルーター Cisco WS-X45-SUP6-E - Supervisor Engine 6-EのPDF インストールと設定の注意をオンラインで閲覧またはダウンロードできます。Cisco WS-X45-SUP6-E - Supervisor Engine 6-E 30 ページ。

Figure 2

Pivot the two module ejector levers out and away from the faceplate.

Step 7

Carefully slide the supervisor engine into the slot until the notches on both ejector levers engage the

Step 8

chassis sides.

Using the thumb and forefinger of each hand, simultaneously pivot in both ejector levers to fully seat the

Step 9

supervisor engine in the backplane connector.

Caution

Always use the ejector levers when installing or removing a supervisor engine. A supervisor engine that

is partially seated in the backplane will not function correctly.

Use a screwdriver to tighten the captive installation screws on each end of the supervisor engine

Step 10

faceplate.

To check the status of the module, follow these steps:

Ensure that the LED labeled Status is green (module operational).

Step 1

When the switch is online, enter the show module command. Verify that the system acknowledges the

Step 2

new module and that the module's status is good.

If the module is not operational, reseat it. If the module is still not operational, contact your customer

Step 3

service representative.

78-18337-01

Installing the Supervisor Engine in the Chassis (Catalyst 4506-E Shown)

45 06

Installation and Configuration Note for the Catalyst 4500 E-Series Supervisor Engine 6-E

Removing the Supervisor Engine