- ページ 16
ネットワーク・ルーター Cisco WS-X45-SUP6-E - Supervisor Engine 6-EのPDF インストールと設定の注意をオンラインで閲覧またはダウンロードできます。Cisco WS-X45-SUP6-E - Supervisor Engine 6-E 30 ページ。
ページを印刷する
Removing the Supervisor Engine
Removing the Supervisor Engine
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments. Statement 1051
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
Warning
when servicing. Statement 1034
Caution
To prevent ESD damage, handle supervisor engines by the carrier edges only.
To remove a supervisor engine from a Catalyst 4500 E-series switch, follow this procedure:
Disconnect any network interface cables attached to the ports on the supervisor engine that you intend
Step 1
to remove.
Loosen the captive installation screws (see
Step 2
Figure 3
1
Grasp the left and right ejector levers and simultaneously pivot the levers outward to release the
Step 3
supervisor engine from the backplane connector.
Installation and Configuration Note for the Catalyst 4500 E-Series Supervisor Engine 6-E
16
Captive Installation Screws and Ejector Levers
Ejector lever
Figure
3).
1
2
Captive screw
Figure 3
shows a close-up of the right ejector lever.
2
78-18337-01