- ページ 5

無線アクセスポイント Cisco WAP150のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco WAP150 13 ページ。 Reboot and reset to factory default settings
Cisco WAP150 にも：マニュアル (4 ページ)

ページを印刷する

Insecure mounting might damage the device or cause injury.

ARNING

Cisco is not responsible for damages incurred by insecure wall-

mounting.

Placement Tips

• Ambient Temperature—To prevent the Cisco WAP150 from

overheating, do not operate it in an area that exceeds an ambient

temperature of 104°F (40°C).

• Air Flow—Be sure there is adequate air flow around the device.

• Mechanical Loading—The Cisco WAP150 should be level, stable, and

secure to prevent it from sliding or shifting out of position.

Connecting the Cisco WAP150

You can perform the initial configuration using either a wired or wireless

connection. The default configuration of the Cisco WAP150 has the Wi-Fi

radio turned on.

To connect the Cisco WAP150 to the wired network:

Connect the Ethernet cable to the Ethernet port of a switch, a router,

TEP

or a PC.

Connect the other end of the network Ethernet cable to the

TEP

Ethernet port of the Cisco WAP150.

If PoE is not provided, plug in the supplied power adapter to

TEP

provide power to the Cisco WAP150.

This wireless default configuration will not allow traffic between WiFi and

Ethernet; users will need to go through the setup wizard to resume the

traffic between WiFi and Ethernet.

To connect the Cisco WAP150 to the network wirelessly:

Use wireless clients to locate the WAP150's SSID (CiscoSB-Setup).

TEP

Use the 'cisco123' passkey to access the access point.

TEP

The system provides a one-time-only access to configure the

OTE

access point using a wireless connection.

Cisco WAP150 Quick Start Guide