- ページ 8

無線アクセスポイント Cisco WAP150のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco WAP150 13 ページ。 Reboot and reset to factory default settings
Cisco WAP150 にも： マニュアル (4 ページ)

ページを印刷する
Cisco WAP150 クイック・スタート・マニュアル
We strongly recommend that you use the Setup Wizard for the first
installation. For more advanced configurations, see the
Administration Guide. A link to the Administration Guide is found in
Where to Go From
Congratulations, you can now start using your Cisco WAP150.

Suggested Next Steps

7
In case of an error while installing, try the troubleshooting procedures
described in this section.

Troubleshooting

If you cannot display the configuration utility, you can test the ability of the
computer to communicate with the Cisco WAP150 by using ping. To use
ping on a computer running Windows:
Verify that the Cisco WAP150 is powered on and the lights indicate
S
1
TEP
the appropriate links.
Locate the Cisco WAP150's IP address. While there are different
S
2
TEP
ways to locate the IP address, this procedure uses Cisco FindIT.
a.
If you have previously downloaded Cisco FindIT, open Internet
Explorer and launch Cisco FindIT. For more information on
downloading Cisco FindIT, see www.cisco.com/go/findit.
b. In the Cisco FindIT display, place your mouse over the Cisco
WAP150's name. The Cisco WAP150's IP address is displayed
along with other device information.
Open a command window by choosing Start > Run and enter
S
3
TEP
cmd.
At the command window prompt, enter ping and the Cisco
S
4
TEP
WAP150's IP address. In this example, we pinged 192.0.2.10.
If successful, you should get a reply similar to the following:
Pinging 192.0.2.10 with 32 bytes of data:
Reply from 192.0.2.10: bytes=32 time<1ms TTL=128
If it fails, you should get a reply similar to the following:
Pinging 192.0.2.10 with 32 bytes of data:
8
Here.
Cisco WAP150 Quick Start Guide